![]() I am fairly certain that I did not damage the ABS wheel sensor when I removed it from the backing plate, but I can’t be positive. Apparently the ABS computer codes cannot be read by my code reader. I have a cheap Actron code reader here, so I plugged it in to try and reset the codes so the light would go out, but it said no codes were found. to get the hub off.Īfter I finished the job and put everything back together, the wheel bearing was nice and quiet again, but the ABS light was on. I had to disconnect the ABS sensor, brake line, etc. Anyway, to do the job, of course the hub was removed from the car so I could press the old bearings out and press the new ones in. As we are in the “rust belt”, it was not a fun job. I recently replaced the right rear wheel bearing on my wife’s 1999 Subaru Forester. To all who may have a suggestion for this problem: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |